CIS-166
December 1994
CURRENT INFORMATION SUMMARY
Opening Instructions for the
KODAK MAX Waterproof One-Time-Use Camera
Wear eye protection when opening all cameras.
Remove Back Cover (c)
Remove Wind Knob
4
1
• Carefully pull up each side of the REAR
HOUSING cover until it is completely
removed.
• Ensure film is completely wound off.
• Insert tool end as shown and pry
WIND KNOB off.
• Remove the black O-RING.
Remove Back Cover (d)
5
Remove Back Cover (a)
2
• To remove the camera, the REAR HOUSING
cover must be completely removed.
• Insert special tool into rectangular hole of
PULL TAB.
Remove Camera from Casing
Remove Back Cover (b)
6
3
5
• Tap the FRONT HOUSING cover on a hard
surface to loosen the camera.
• Pry up on PULL TAB to initiate opening.
• Remove the camera from the housing.
• Remove the film in the same way as typical
Fun Saver 35 cameras.
CAUTION: To avoid tool slippage,
be sure tool is fully engaged with
the camera body before attempting
opening task.
• Place in recycle bin.
• Return to Kodak for recycling.
7
©Eastman Kodak Company, 1996
|