SIDE BY SIDE BUILT-IN REFRIGERATOR
Installation Guide
IMPORTANT: READ AND SAVE THESE INSTRUCTIONS. INSTALLATION REQUIRES 2 OR MORE PEOPLE.
REFRIGERADOR EMPOTRADO
DE DOS PUERTAS
Manual de instalación
IMPORTANTE: LEA Y GUARDE ESTAS INSTRUCCIONES. LA INSTALACIÓN REQUIERE DE 2 O MÁS PERSONAS.
RÉFRIGÉRATEUR ENCASTRÉ CÔTE À CÔTE
Guide d’installation
IMPORTANT : LIRE ET CONSERVER CES INSTRUCTIONS. L’INSTALLATION NÉCESSITE L’INTERVENTION DE 2 PERSONNES OU PLUS.
Table of Contents/Índice/Table des matières..................................................................2
2316565B
REFRIGERATOR SAFETY
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
You can be killed or seriously injured if you don't immediately
follow instructions.
DANGER
You can be killed or seriously injured if you don't
instructions.
follow
WARNING
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not
completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure to do so can result in death or serious injury.
3
MODELS
Side by Side Non-Dispensing Refrigerators
Architect® Series
Classic Series
Features wraparound styling that complements the contoured
door handles. This series provides a warm commercial-looking
built-in refrigerator.
Features factory-installed, traditional style trim to provide a
“framed” look. This series requires the installation of custom
panels that are not included.
KSSC36FTS
KSSC42FTS
KSSC48FTS
KSSS36FTX
KSSS42FTX
KSSS48FTX
Overlay Series
Features factory-installed, overlay style trim to provide a
“frameless” look. This series requires the installation of custom
panels, handles, and standoffs.
KSSO36FTX
KSSO42FTX
KSSO48FTX
4
Side by Side Dispensing Refrigerators
Architect® Series
Classic Series
Features wraparound styling that complements the contoured
door handles. This series provides a warm commercial-looking
built-in refrigerator.
Features factory-installed, traditional style trim to provide a
“framed” look. This series requires the installation of custom
panels that are not included.
KSSC36QTS
KSSC42QTS
KSSC48QTS
KSSS36QTB
KSSS36QTW
KSSS36QTX
KSSS42QTB
KSSS42QTW
KSSS42QTX
KSSS48QTB
KSSS48QTW
KSSS48QTX
Overlay Series
Complete Series
Features factory-installed, overlay style trim to provide a
“frameless” look. This series requires the installation of custom
panels, handles, and standoffs.
Features factory-installed stainless steel trim and panels to create
a sleek, contemporary look.
KSSP36QTS
KSSP42QTS
KSSP48QTS
KSSO36QTB
KSSO42QTB
KSSO48QTB
5
INSTALLATION REQUIREMENTS
Tools and Parts
Location Requirements
IMPORTANT:
The refrigerator can be recessed in an opening between cabinets
or installed at the end of a cabinet run using a side panel to
enclose the refrigerator.
I
Installer: Leave Installation Instructions with the homeowner.
I
Homeowner: Keep Installation Instructions for future
reference. Save these Installation Instructions for the local
electrical inspector’s use.
WARNING
TOOLS NEEDED:
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
I
Hand drill or electric drill
(properly grounded)
I
I
I
Torx®†T27 screwdriver
Explosion Hazard
¹¹⁄₃₂" nut driver
I
I
I
I
I
Drill bits
³⁄₈" and ¹⁄₂" open-end
wrenches
Keep flammable materials and vapors, such as
gasoline, away from refrigerator.
Two adjustable wrenches
Phillips screwdriver
Small level
I
I
I
I
⁵⁄₃₂" Allen wrench
¹⁄₄" and ⁵⁄₁₆" socket drivers
Tape measure
Failure to do so can result in death, explosion, or fire.
IMPORTANT:
Appliance dolly
I
Observe all governing codes and ordinances.
Utility knife
I
It is recommended that you do not install the refrigerator near
an oven, radiator, or other heat source.
PARTS NEEDED:
I
I
I
Six #8 x 3" (7.6 cm) wood screws (longer screws may be needed)
I
I
I
I
I
Do not install in a location where the temperature will fall
below 55°F (13°C).
One or two 2" x 4" x 32" (5 cm x 10 cm x 81 cm) wood board(s)
Floor must support the refrigerator weight, more than 600 lbs
(272 kg), door panels and contents of the refrigerator.
Order factory panels, make custom panels or consult a
qualified cabinetmaker or carpenter to make the panels.
Ceiling height must allow for side tipping radius. See “Tipping
Radius.”
Classic Series: Order factory panels, make custom panels, or
consult a qualified cabinetmaker or carpenter to make the
panels. See “Classic Series Custom Panels” for more
information.
Location should permit door to open fully. See “Door Swing
Dimensions.”
Overlay Series: Make custom panels, or consult a qualified
cabinetmaker or carpenter to make the panels. See “Overlay
Series Custom Panels and Handle Kits” for more information.
Location must permit top grille removal. See “Opening
Dimensions.”
Architect® and Complete Series are shipped complete.
Opening Dimensions
I
If you are connecting the water line directly to copper tubing
and not to a shutoff valve, you need a ferrule, a union, and a
¹⁄₄" (6.35 mm) compression fitting.
I
To avoid tipping during use, the solid soffit must be within 1"
(2.5 cm) maximum above the refrigerator. If the solid soffit is
higher than 1" (2.5 cm) or one is not available, then the
refrigerator must be braced.
If the anti-tip boards are needed, they must be attached to
the rear wall studs 80" to 90" (203 cm to 229 cm) above the
floor. See “Install Anti-Tip Boards” for more information.
NOTE: A clearance of ¹⁄₂" (1.3 cm) must be maintained above
the top grille in order for the top grille to be removed.
¹⁄₂"
(1.3 cm)
†®TORX is a registered trademark of Textron Innovations Inc.
6
I
I
A grounded 3 prong electrical outlet should be placed within
4" (10.2 cm) of the right side cabinets or end panel. See
“Electrical Requirements” for more information.
Electrical Requirements
The water shutoff should be located in the base cabinet on
either side of the refrigerator or some other easily accessible
area. If the water shutoff valve is not in the cabinets, the
plumbing for the water line can come through the floor or the
back wall. See “Water Supply Requirements” for more
information.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
80" - 90"
(203-229 cm)
4"
(10.2 cm)
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
83¹⁄₂" (212.1 cm) min.
84³⁄₄" (215 cm) max.
to bottom of solid soffit
Before you move your refrigerator into its final location, it is
important to make sure you have the proper electrical
connection.
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only, 15- or 20-amp fused, grounded
electrical supply is required. It is recommended that a separate
circuit serving only your refrigerator be provided. Use an outlet
that cannot be turned off by a switch. Do not use an
extension cord.
77"
(196 cm)
A
Width
(see chart following)
IMPORTANT: If this product is connected to a GFCI (Ground
Fault Circuit Interrupter) protected outlet, nuisance tripping of the
power supply may occur, resulting in loss of cooling. Food quality
and flavor may be affected. If nuisance tripping has occurred,
and if the condition of the food appears poor, dispose of it.
6"
(15.2 cm)
NOTE: Before performing any type of installation, cleaning, or
removing a light bulb, remove the top grille and turn the master
power switch to OFF or disconnect power at the circuit breaker
box.
When you are finished, turn ON the master power switch or
reconnect power at the circuit breaker box. Then reset the control
to the desired setting.
1"
6"
(2.54 cm)
6"
(15.2 cm)
(15.2 cm)
24"
(60.96 cm) min.
Model Width A (as shown above)
36
42
48
35¹⁄₂" (90.2 cm) to 35³⁄₄" (90.8 cm)
41¹⁄₂" (105.4 cm) to 41³⁄₄" (106.1 cm)
47¹⁄₂" (120.7 cm) to 47³⁄₄" (121.3 cm)
NOTE: Flooring under refrigerator must be at same level as
the room. Face of cabinetry must be plumb.
7
|